Filter
Top Products
Useful Information
43
For assistance, please visit http://www.panasonic.com/help
Making/answering calls, intercom
Caller ID
I fully charged the batteries, but )
still flashes or 0 is displayed.
L Clean the charge contacts and charge again (page 9).
L It is time to replace the batteries (page 8).
I fully charged the batteries, but
the operating time seems to be
shorter.
L Clean the battery ends (S, T) and the charge contacts with a
dry cloth and charge again.
Problem Cause/solution
w is flashing. L The handset is too far from the base unit. Move closer.
L The base unit’s AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
L You are using the base unit or handset in an area with high
electrical interference. Re-position the base unit and use the
handset away from sources of interference.
L The handset is not registered to the base unit. Register it (page
27).
Noise is heard, sound cuts in and
out.
L You are using the base unit or handset in an area with high
electrical interference. Re-position the base unit and use the
handset away from sources of interference.
L Move closer to the base unit.
L If you use a DSL/ADSL service, we recommend connecting a
DSL/ADSL filter between the base unit and the telephone line
jack. Contact your DSL/ADSL provider for details.
The base unit and/or handset
does not ring.
L The ringer volume is turned off. Adjust the ringer volume (page
14).
L Silent mode is turned on. Turn it off (page 25).
I cannot make a call. L The dialing mode may be set incorrectly. Change the setting
(page 12).
L The handset is too far from the base unit. Move closer and try
again.
I cannot make long distance calls. L Make sure that you have long distance service.
Problem Cause/solution
Caller information is not
displayed.
L You must subscribe to Caller ID service. Contact your service
provider/telephone company for details.
L If your unit is connected to any additional telephone equipment
such as a Caller ID box or cordless telephone line jack, plug the
unit directly into the wall jack.
L If you use a DSL/ADSL service, we recommend connecting a
DSL/ADSL filter between the base unit and the telephone line
jack. Contact your DSL/ADSL provider for details.
L The name display service may not be available in some areas.
Contact your service provider/telephone company for details.
L Other telephone equipment may be interfering with this unit.
Disconnect the other equipment and try again.
Problem Cause/solution
TG106x(e).book Page 43 Friday, January 16, 2009 10:45 AM