Filter
Top Products
Useful Information
41
For assistance, please visit http://www.panasonic.com/help
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
Display message Cause/solution
Busy L The called unit is in use.
L Other units are in use and the system is busy. Try again
later.
L The handset you are using is too far from the base unit.
Move closer and try again.
L The handset’s registration may have been canceled. Re-
register the handset (page 27).
Check tel line L The supplied telephone line cord has not been connected
yet or not connected properly. Check the connections
(page 8).
Error!! L Recording was too short. Try again.
Failed L Phonebook copy failed (page 19). Confirm the other unit
(the receiver) is in standby mode and try again.
Incomplete L Phonebook copy is incomplete. The receiver’s phonebook
memory is full. Erase the unnecessary phonebook entries
(page 17) from the other unit (the receiver) and try again.
Memory full L The phonebook memory is full. Erase unnecessary
entries (page 17).
L Message memory is full. Erase unnecessary messages
(page 32, 33).
Messages full L Message memory is full. Erase unnecessary messages
(page 32, 33).
No link. Reconnect base AC
adaptor.
L The handset has lost communication with the base unit.
Move closer to the base unit and try again.
L Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
L The handset’s registration may have been canceled. Re-
register the handset (page 27).
Requires subscription to
Caller ID.
L You must subscribe to a Caller ID service. Once you
receive caller information after subscribing to a Caller ID
service, this message will not be displayed.
Use rechargeable battery. L A wrong type of battery such as Alkaline or Manganese
was inserted. Use only the rechargeable Ni-MH batteries
noted on page 4, 5.
TG106x(e).book Page 41 Friday, January 16, 2009 10:45 AM