Filter
Top Products
➡
41
◆ Setting the Handset PIN
You can program a 4 digit password for the handset. The factory pre-set is 0000.
Changing the password may prevent the unauthorised use of your unit by another person.
S/U
Ł
Y
or V
Ł S/U Ł
Y
or V
Ł Enter Old PIN Ł Enter New PIN
Select
‘Other
Option’
Select
‘Change
Hset PIN’
Enter the current
4-digit handset
PIN.
In the ‘Setting Handset’ mode
Enter the new 4-digit
PIN TWICE.
If 2nd PIN entry is
incorrect, an error
tone sounds and
display returns to
‘New PIN’. If PIN is
correct, a confirmation
tone sounds.
NOTE: Once you have programmed the password, you
cannot confirm it. We recommend you write down the
password. If you forget it, please consult your nearest
Panasonic Service Centre.
◆ Registering a Handset to a Base Unit
The handset supplied with the base unit is already registered. If an optional
handset/base unit is purchased, the following procedure needs to be carried out before
initial use.
Z and hold (Ï) on base unit for more than10 seconds. A series of beeps begin
to sound.
NOTES:
• Charge the optional handset batteries for about 10 hours before initial use.
• Register the handset number within 1 minute. If not registered within 1 minute,
ZP on the handset to cancel the programming mode. Then re-start registration.
• Calls (both incoming and outgoing) can be conducted only via the displayed base
unit (even if the radio areas overlap with neighbouring base units).
S/U
Ł
Y
or V Ł S/U Ł
Y
or V Ł S/U Ł
Y
or V Ł Please Wait... Ł
Select
‘Registration’
Select
‘Register
H/set’
Select Base
No. to register
handset (1-4).
In the ‘Setting Handset’ mode
Handset searches
selected base.
Enter Base PIN Ł
Y
or V Ł
Please Wait...
• If registration is successful, a confirmation tone
sounds and display returns to the standby mode.
The selected base number is displayed in the
standby mode.
• If registration is not successful within 5 minutes, an
error tone sounds and display returns to original
standby mode.
30678_KX-TCD705 Dutch_a_English 22/6/01 9:22 am Page 41