Before Requesting Help ➡
Problem Cause and Remedy
“
Î
” flashes and an alarm tone • You are too far from the base unit. Move closer and
sounds when you
ZOor %
. • try again.
• Plug in the AC adaptor.
• The handset has been cancelled or has not been
registered. Register the handset in the base unit
(page 41).
• If the handset is registered to more than one base unit,
check ‘selecting the base unit access’ (page 42).
A busy tone sounds when you • Another handset is in use.
ZOor %
.
“
Î
” flashes during a conversation • The handset is out of range. Move closer to the
and the call is disconnected. • base unit and make the call again.
• Plug in the AC adaptor.
The unit does not work. • Turn the power ON (page 12).
• Check the settings.
• Charge the batteries fully (page 7).
• Clean the charge contacts and charge again (page 7).
• Unplug the AC adaptor and turn the power OFF to reset.
Plug in the AC adaptor and turn the power ON. Then try
again.
• Re-install the handset batteries (page 7) and try again.
• The handset has been cancelled or has not been
registered. Register the handset (pages 39, 41).
You cannot dial. •
Check that the dialling mode selection is correct (page 44).
• The dialled number is restricted. Cancel the number
(page 45).
• Key lock mode is set. Cancel the mode (page 36).
Static, sound cuts in/out, fades. • Locate the handset and base unit away from other
Interference from other electrical • electrical appliances.
units. • Move closer to the base unit.
The handset does not operate • Turn the power ON (page 12).
or ring. • The ringer is set to OFF. Select the desired volume
level (page 37).
The base unit does not ring. • The ringer is set to OFF. Select the desired volume
level (page 44).
49
KX-TCD705BX 12/7/01 2:28 pm Page 49