Filter
Top Products
Making a Call
(For further information on making calls, see pages 13-14.)
1. ZO
2. Dial a phone number
The dialled number is displayed.
(If a number is entered incorrectly, ZP).
After a few seconds, the display will start showing the length of the call.
12
Terminating a Call
1. To hang up, ZP.
• The handset will return to the standby mode.
• The dialled number is stored in the redial memory.
Turning the Power On
1. Z and hold P
• After all characters briefly appear a confirmation tone
sounds. The display will change to the standby mode when
the button is released.
• The current connected base unit number is displayed (–1–)
• The number of New Caller ID calls received are displayed (eg. 02)
• You can choose whether to display the base unit number, handset number,
clock or no display in the standby mode (see page 31).
Basic Start-up Operations
-1-œœœœœœœ02
Î Ò
Answering a Call
(For further information on answering calls, see page 15.)
1. ZO
• You can also answer a call by pressing any dialling button
K to I, J or L (-Any Key Answer).
After a few seconds, the display will start showing the length of the call.
Turning the Power Off
Make sure that the unit is in the standby mode.
1. Z and hold P until a long beep sounds
• The display will go blank.
(On location of the handset in the base unit, the battery icon will display even
after power off).
31939_KX-TCD700CX_Czech 18/6/01 1:54 pm Page 12