Panasonic KX-TCD650E Cordless Telephone User Manual


 
If the
ÛÛ
icon flashes after a few
telephone calls even when the
handset batteries have been fully
charged, the batteries must be
replaced.
! Charge new batteries for
approximately 15 hours before
initial use.
(The telephone line cord must
not be connected to the
telephone socket at this time).
If the batteries are removed, the
battery icon is reset to
ÛÛ
(less
than 30% capacity). In this case,
even if fully charged batteries are fit-
ted, the icon remains as
ÛÛ
until a
full charge cycle is complete.
On replacing the batteries, ensure
that the correct battery type is
selected (see ‘Handset Settings’).
! The batteries must be charged
for approximately 15 hours
before initial use.
After the batteries have been
inserted into the handset, place the
handset in the powered up base unit.
(The telephone line cord must
not be connected to the
telephone socket at this time.
Please leave your standard
telephone connected until
battery charging is complete).
The batteries are fully charged only
when
ÒÒ
is flashing.
(Before Initial Use)
(After Initial Use)
Turning the Power ON/OFF
Turn Power OFF
From the standby mode, Z and
hold ± until a long tone sounds.
The display goes blank. If you put
the handset in the base unit, the
battery icon will display.
Answering Calls
When the phone rings,
ZZ
,
KK--II
,
NN
,
JJ
or
LL
.
When an external call is incoming,
you can temporarily turn off the
handset ringer.
During an incoming call, Z and
hold U.È is displayed and the
handset ringing stops. (This function
will not work when the handset is on
the base unit or if an internal call is
incoming.)
When the battery icon flashes (and,
if programmed, battery low alarm
sounds), the handset should be
charged immediately because there
is little energy left in the batteries.
Replacing the batteries
Using the Telephone
Battery Charging
Turn Power ON
Z and hold ±.
When button is released, display
changes to the standby mode and a
confirmation tone sounds.
Battery Life
Battery life is dependent on use and
conditions but in general when using
fully charged Ni-MH batteries:
Talk time: 20hrs approx.
Standby time: 200hrs approx.
When using Ni-Cd batteries (based
on 800mA per hour)
Talk time: 12hrs approx.
Standby time: 100hrs approx.
(Times indicated are for peak performance)
The batteries reach peak performance
after several full charge / discharge
cycles.
The batteries cannot be overcharged
unless they are repeatedly removed
and replaced.
If battery life is shortened then
please check that battery and charge
terminals are clean.
For maximum battery life it is
recommended that the handset is not
recharged until battery icon flashes
(
ÛÛ
).
4 Helpline Tel.No. : U.K. 08700 100 076 R.O.I. 01289 8333
650e eng Baseline TXT 23 4 02 23/4/02 12:25 pm Page 4