Filter
Top Products
18
For Optional Multi-Unit Users
Cancelling a Base
Unit
Follow steps 1 to 5 of
“Registering a Handset to a Base
Unit”, then:
ZZSS
/
UU
to select:
Cancelling a Handset
Each handset can cancel itself or
another handset.
From the standby mode,
ZZVV
.
ZZSS
/
UU
to select
sseettttiinngg bbss..
ZZVV
.
ZZGG
when
iinnppuutt ccooddee
is dis-
played.
Enter base unit PIN (4 digits).
ZZAA -- FF
to select handset
to cancel.
ZZYY
.
(Select Base Unit):
ZZVV
.
ZZSS
/
UU
to select
aauuttoo
or a spe-
cific base unit 1 -4 (only regis-
tered base unit numbers are dis-
played).
ZZVV
to confirm selection.
Calls (both incoming and outgoing), can
be conducted only via the selected base
unit, even if the radio cells overlap with
neighbouring base units.
Selecting a Base Unit
When auto (Automatic Base Unit
Access) is selected, if you move out-
side of the radio range of the current
base unit the handset automatically
searches for other registered base
units.
When a specified base unit is selected,
the handset will access that base unit
only.
Follow steps 1 to 3 of “Registering a
Handset to a Base Unit”, then:
ZZSS
/
UU
to select:
You can use your handsets as a 2-way
intercom. For example, when Handset 1
calls Handset 2:
Handset 1-
ZZNN
.
ÏÏ
blinks.
ZZBB
(desired handset num-
ber).
Handset 2 (ringing) -
ZZ‰‰
to answer.
Handset 1 and 2 -
ZZ±±
to end the call.
! Intercom calls can be conducted
within the radio cell of the current
base unit, but not with units in
neighbouring radio areas.
(Cancel a Base Unit)
You can cancel any base unit that your
handset is registered to.
ZZVV
.
Enter handset PIN (4 digits).
ZZSS
/
UU
to select base unit(s) to
cancel.
ZZVV
to set selection.
Selected base number(s) flash(es).
ZZVV
.
ZZSS
/
UU
to select
yyeess
(Yes) or
nnoo
(No).
ZZVV
to confirm selection.
If selection was yes, cleared is dis-
played briefly.
select bs
Intercom Between
Handsets
cancel base
650bx engversion 19 6 02 19/6/02 6:59 am Page 18