Filter
Top Products
17
For Optional Multi-Unit Users
You can register and operate your
handset with up to 4 base units. Each
base unit forms 1 radio cell. If the indi-
vidual bases are
linked to the
same tele-
phone
line then
you can
extend
the oper-
ating
range of
the system
by posi-
tioning the
bases so
that the
two
radio
cells
overlap.
If the
handset is
set to AUTO
base selection, then in
standby mode the hand-
set will automatically
swap to the second base
if the range on the first
base is exceeded.
It is not possible to
transfer calls between bases (only
between handsets linked to the same
base unit).
Operating Additional
Base Units
NOTE: Calls are disconnected
when the handset moves from one
radio cell to another.
Registering a Handset
to a Base Unit
1
2
3
5
4
Radio Cell
Eg.
Additional
handsets
(KX-A120EX)
registered with
2 base units.
Additional KX-A120EX handsets are
available to purchase separately. Up
to 6 handsets can be registered to a
single base unit. Using additional
handsets allows you to have an inter-
com call while simultaneously con-
ducting a call to an outside line.
(Registration):
ZZVV
.
5
(Register Handset):
ZZVV
.
ZZ
and hold
ÏÏ
on the base unit
for 10 seconds. A base registration
tone sounds
! Handset must be registered with-
in 1 minute. If over 1 minute
ZZ±±
, then restart registration.
ZZSS
/
UU
to select
bbaassee 11--44
(base 1-4).
ZZVV
.
Enter base unit PIN (4 digits -
factory preset is 0000).
ZZVV
.
When handset and base unit
connect a confirmation tone
sounds.
If handset registration is not
successful within 5 minutes, an
error tone sounds.
register hs
Operating Additional
Handsets
registration
The handset supplied with the base
unit is already registered. If an optional
handset is purchased, it must be regis-
tered as follows.
! Charge the optional handset
batteries for 15 hours before
initial use.
From the Standby mode,
ZZVV
.
ZZSS
/
UU
to select
sseettttiinngg hhss
(Setting Handset).
ZZVV
.
ZZSS
/
UU
to select:
4
3
2
1
650bx engversion 19 6 02 19/6/02 6:59 am Page 17