Filter
Top Products
45
Advanced Operation
Save DIRECT#
1
Set recall time
43
1
=Yes
Recall time
:100ms
43
1
=Save
4
Press (›) or (‹) repeatedly until the arrow
points to “Set recall time”.
5
Press FWD/EDIT (fl) (Yes key).
6
Press (›) or (‹) repeatedly until the
desired time is displayed.
7
Press FWD/EDIT (fl) (Save key).
≥A beep sounds.
≥To return to the standby mode, press (FUNCTION/EXIT/CH).
≥You can exit the programming mode any time by pressing (FUNCTION/EXIT/CH).
≥Users in Australia can access Telstra’s “EASY CALL” service by having the
recall time set at 100 msec (this is the factory default setting), and then follow
Telstra’s “EASY CALL” instructions to operate this service.
≥If you are connected via a PBX, a longer or shorter recall time may be necessary
to use PBX functions (transferring a call etc.). Consult your PBX supplier for the
correct setting.
For Call Waiting Service Users in New Zealand
Make sure the recall time is set to 600 msec for use with Telecom’s
Call Waiting Service. Press (RECALL) if you hear a call-waiting tone
while talking.
≥The first call is put on hold and you can answer the second call.
≥To return to the first caller, press (RECALL) again.
≥Your telephone company may not support the second caller display
feature.