Filter
Top Products
Preparation
For assistance, please visit http://www.panasonic.com/help 9
Setting up the base
unit
Connecting the AC adaptor
and telephone line cord
Connect the telephone line cord until it
clicks into the base unit and telephone
line jack (A). Connect the AC adaptor
cord (B) by pressing the plug firmly
(C).
LUse only the included Panasonic AC
adaptor PQLV203.
Note:
LThe AC adaptor must remain
connected at all times. (It is normal for
the adaptor to feel warm during use.)
LThe AC adaptor should be connected
to a vertically oriented or floor-
mounted AC outlet. Do not connect
the AC adaptor to a ceiling-mounted
AC outlet, as the weight of the
adaptor may cause it to become
disconnected.
LThe unit will not work during a power
failure. We recommend connecting a
corded telephone to the same
telephone line or to the same
telephone line jack using a Panasonic
T-adaptor (page 5).
If you subscribe to a DSL service
Please attach a noise filter (contact your
DSL provider) to the telephone line
between the base unit and the
telephone line jack in the event of the
following:
– Noise is heard during conversations.
– Caller ID features do not function
properly.
Setting up the handset
Connecting the AC adaptor
LUse only the included Panasonic AC
adaptor PQLV208.
(120 V AC, 60 Hz)
A
B
To single-line
telephone
jack (RJ11C)
Hook
C
Available model:
KX-TG6072/KX-TG6073/KX-TG6074
Noise filter
To single-line
telephone
jack (RJ11C)
(120 V AC, 60 Hz)
Fasten the AC adaptor cord to
prevent it from being disconnected.
Bottom of the charger
Hooks
Hooks
TG607X.book Page 9 Tuesday, December 12, 2006 1:56 PM