Filter
Top Products
Programmable Settings
42 For assistance, please call 1-800-211-PANA (7262).
Base unit settings
Base unit ringer volume
4 levels (high/medium/low/off) are
available. The default setting is HIGH.
Important:
LMake sure the base unit is not being
used.
Press {<} or {>} repeatedly to select the
desired volume.
LTo stop ringing, press {STOP}.
To turn the ringer off, press and hold {<}
until the unit beeps 2 times.
L“
O” will be displayed.
Note:
LWhen the ringer volume is set to off, the
base unit will not ring for outside calls
and it will ring at the low level for
intercom calls.
LWhen the ringer volume is set to off, the
base unit will not announce caller names
(page 26).
Base unit ringer tone
You can change the base unit ringer tone
heard when an outside call is received.
There are 3 tones and 4 melodies. The
default setting is “Tone 1”.
This feature must be set by using the
handset.
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press {>}.
3 Scroll to “Set base unit” by pressing
{V} or {^}, then press {>}.
4 Scroll to “Ringer tone” by pressing
{V} or {^}, then press {>}.
5 Press {V} or {^} repeatedly to select
the desired setting.
LYou can also select the ringer tone by
pressing {1} to {7}.
LIf the ringer volume has been turned
off, the base unit will not ring.
6 Press {Save}, then press {OFF}.
Note:
LIf you subscribe to a distinctive ring
service (such as IDENTA-RING), select
a tone (Tone 1 to 3). If you select a
melody, you will not be able to
distinguish lines by their ringers.
LIf you select one of the melody ringer
patterns, the ringer will continue to
sound for several seconds if:
– the caller hangs up before you answer
the call.
– another person answers the call using
another phone connected on the
same line.
Base unit interrupt tone
This tone lets you know when you receive
a call while you are on an intercom call
(page 31).
“2” (default): The tone will sound 2 times.
“On”: The tone will sound for as long as the
line rings.
“Off”: Turns this feature off.
This feature must be set by using the
handset.
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press {>}.
3 Scroll to “Set base unit” by pressing
{V} or {^}, then press {>}.
4 Scroll to “Interrupt tone” by
pressing {V} or {^}, then press {>}.
5 Press {V} or {^} repeatedly to select
the desired setting.
6 Press {Save}, then press {OFF}.
TG5451_5452_5453.book Page 42 Friday, February 18, 2005 11:38 AM