Filter
Top Products
Canceling Registration/Re-registration
70
• You can stop registration by pressing [OFF] on the handset and pressing
LOCATO R/INTERCOM [ ], [], [], [] or [] on the base unit.
• If “Wrong handset Refer to manual” is displayed, the handset you tried to
register is not for this base unit. This handset is for KX-TG6500 base unit. The
accessory handsets for this base unit are KX-TGA520 and KX-TGA523. To order,
see page 3.
5 Base unit: Press and hold LOCATOR/INTERCOM [ ], [], [], []
or [] for 3 seconds.
• The CHARGE indicator flashes. After the CHARGE indicator starts flashing,
the rest of the procedure must be completed within 1 minute.
6 Handset:
(1) Press the soft key ( ).
(2) Wait until a long beep sounds and the
display shows the new extension number
(ex. extension number 2).
• Registration is complete.
If you have not canceled the handset’s registration at the previous base unit
(p. 68), the handset number remains in that base unit’s memory. To erase the
handset number from the previous base unit, see the base unit’s Operating
Instructions. For the KX-TG5210, KX-TG5212 or KX-TG5213 base unit:
(1) Press and hold LOCATOR/INTERCOM [] for 3 seconds, and (2) Press
and hold LOCAT OR/INTERCOM [ ], [], [] or [] for the handset that you
do not want for 5 seconds. A long beep sounds, then the handset number is
erased.
OK
Press LOCATOR
on base unit
for 3 sec.
Then press OK
BOX
1
BOX 2
OK
SP
I
PRIVACY
1
Handset [2]
Registered
IN USE
[
2
]