Filter
Top Products
Programmable Functions
12
Date and Time
“” flashes on the base unit display if the clock has not been
set. Set the clock by following the steps below.
• When entering the time in step 3, you cannot enter numbers greater than 12.
Do
not use military time.
(To set 13:00 hours, enter “0100”, then select “
PM
” in
step 4.)
To check the date/time,
repeat steps 1 and 2 above.
• The current date/time is displayed. When finished, press
[OFF]
.
1
Press
[MENU]
.
2
Scroll to “
Date and time
” by pressing
[]
or
[]
, then press
Select
.
3
Enter 2 digits each for month, day, and
year. (Ex. To set Apr. 7, 2003, enter “04 07
03”.)
Enter 4 digits for time (hour and minute). (Ex.
To set 9:30, enter “0930”.)
• If you enter a wrong number, press
[]
or
[]
to
move the cursor to the incorrect number. Enter the
correct number.
4
Select “
AM
” or “
PM
” by pressing
AM/PM
.
5
Press
Save
, then press
[OFF]
.
• The clock is set and “” disappears from the
base unit display.
• If 3 beeps sound after pressing
Save
, the setting
is not correct. Start again from step 3.
If a power failure occurs, the time setting may be incorrect. When “” flashes
on the base unit display, adjust the date/time.
For Caller ID service users (p. 27)
• Caller ID information will reset the clock after the first ring if the adjusted time is
incorrect.
• If the time has not previously been set, Caller ID information will not adjust the
clock.
• Caller ID information will automatically adjust the clock for daylight saving time.
Handset
>
>
Date and time
Exit Select
>
>
1
2
>
>
Date:12.31.2003
Time:12:00 AM
AM/PM Save
Date:04.07.2003
Time:09:30 AM
AM/PM Save
Example
1
0
Date:04.07.2003
Time:09:30 AM
AM/PM Save
0