Filter
Top Products
1.5 Before Leaving Your Desk
74 User Manual
button or Message/Ringer Lamp, the corresponding button or lamp turns on when a message has been left.
You can also perform the following operations:
• You can record, play, or erase a personal BV OGM for your personal message area.
• The operator or manager can record, play, or erase a common BV OGM for the common message
area. Refer to "2.1.6 Recording, Playing, or Erasing Common BV Outgoing Messages".
• You can set incoming calls to be forwarded to your personal message area, when you cannot
answer them.
• You can leave a voice message in the personal message area of another extension, even if the
extension has not been set to forward incoming calls to its personal message area, or even if no
personal/common BV OGM has been recorded (Direct Message).
When a caller leaves a voice message using the Direct Message feature, the voice message is
automatically linked to the caller information recorded in the corresponding call log.
• You can access the personal/common message area from an outside telephone by using a
preprogrammed voice message access code. The code to enter differs depending on whether you
are calling directly to an extension (that is forwarded to the extension's message area) or to the
common message area, or you are calling with DISA.
Call Log
When viewing caller information, you can see whether the caller left a voice message. For more details, refer
to "1.9.1 Calling with the Incoming Call Log".
Notes
• If you set the Voice Mail Integration feature, the BV feature will not function.
• When another extension user is recording or erasing a personal/common BV OGM, you cannot
perform any operations using the BV feature. When another extension user or an outside caller is
performing operations other than those mentioned above, you may not be able to use the BV
feature. In this case, wait a few minutes and try again.
Recording, Playing, or Erasing Personal BV Outgoing Messages
To record
PT/SLT
On-hook.
Record a message.
Off-hook.
Enter 723. Enter 1.
C.Tone
2 3 17
A PT user can play back
the message by pressing the
AUTO DIAL/STORE button
instead of going on-hook.
Enter #.
An SLT user can enter "0"
instead of "#".