Filter
Top Products
Special Features
Telephone System
For assistance, please call: 1-800-211-PANA(7262)
51
Key Tone
You can select whether or not the handset keys will sound tones (key tone,
confirmation tone, error tone). The factory preset is ON.
Re-registering the Handset
If “No link to base. Move closer to base, try again.” is displayed
even when using the handset near the base unit, the handset may have lost
communication with the base unit. You need to re-register the handset to the base
unit.
• Make sure the base unit is not being used.
• Have both the handset and base unit nearby during registration.
• Follow steps 1and 2 listed below. You have about 1 minute to complete
them.
• If the handset beeps 3 times and “Error!!” is displayed, an error occurred. Try
again from step 1.
• You can stop registration by pressing [OFF] on the handset, and pressing
[LOCATOR/INTERCOM] on the base unit.
1 Press [MENU].
2 Scroll to “Initial setting” by pressing [
d
]
or [
B
], then press Select.
3 Scroll to “Key tone” by pressing [
d
] or [
B
],
then press Select.
4 Select “Off” or “On” by pressing [
d
] or [
B
].
5 Press Save, then press [OFF].
1 Base unit: Press and hold [LOCATOR/INTERCOM] until a beep sounds.
• The CHARGE indicator flashes.
2 Handset: Press and hold [FLASH/CALL
WAIT] until “Handset
Registering” is displayed.
• When registration is complete, a beep sounds
from the handset.
• Wait for 20 seconds after registration is
complete while the handset establishes
communication with the base unit.
Handset
Initial setting
Back Select
K
d
BL
Key tone
Back Select
K
d
BL
Key tone
:On
Back Save
K
d
BL
Handset & Base Unit
Handset
Registering
Handset [1]
Registered
PQQX13988YA.book 51 ページ ２００４年２月５日 木曜日 午前１０時５分