Filter
Top Products
4
Installation
Installation
Installing batteries (supplied) in the phone
Warnings
Before opening the battery compartment, make sure the telephone
is disconnected from the telephone line.
You must install 4 AAA Alkaline batteries (supplied) in the phone
base to retain memory and CID information when the telephone
is disconnected from the line.
1. Use a at-blade screwdriver or tip of a pen to lift and remove the
battery compartment door.
2. Insert four AAA batteries into the compartment as indicated by the
polarity symbols.
3. Snap the battery compartment door back into place.
When this symbol appears on the display or the display dims, replace
the batteries. Always use 4 new high quality Alkaline AAA batteries.
If you have a Broadband line
If you connect your telephone to a line with a broadband connection, you
must connect an in line lter (not supplied) between the telephone socket and
your phone base to ensure that your broadband and TP30 will work properly.
If you do not install the lter you will experience interference on the
cordless phone and your Broadband may suffer dropouts. Please refer to
the user guide of the in line lter for installation.
In a home with broadband, every telephone, fax or answering system
must have a in-line lter connected, not just the one at the telephone
point that your modem is connected to.
Additional in-line lters can purchase from electronic stores.
Connecting the telephone
1. Plug one end of the curly cord into the socket on the handset.
2. Plug the other end of the curly cord into the left side of the phone.
3. Plug one end of the telephone line cord into the jack at the back of the
base, and the orher end into the wall socket.
4. Pick up the handset and listen for dial tone.