Oricom TP30 Amplified Phone User Manual


  Open as PDF
of 24
 
8
Basic settings
Basic settings
1. After installing the batteries, the display should flash the word
ENGLISH.
If not press and hold for approximately 4 seconds.
2. Select the desired language using or . Press DELETE/OK button.
3.Selectthedesiredcontrastsetting(2=Default)using or .
Press DELETE/OK button.
4. Set the month using or . Press DELETE/OK button.
5. Set the day using or . Press DELETE/OK button.
6. Set the hour (00-23) using or . Press DELETE/OK button.
7. Set the minute using or . Press DELETE/OK button.
Display(LCD)Contrast/Time Setting
If you wish to change the language, contrast, time settings at a later date,
press and hold button for approximately 4 seconds and repeat steps 2-7
above.
Select country version
1. For New Zealand Select Recall = 600 on the switch on the rear side of
the unit, New Zealand Recall/ash time is 600ms, the unit is now set
uptoinsert0/00whenreceivingCIDloginaccordancewithTelecom
NZ requirements. Or for Australia Select Recall = 100.
2.Liftandreplacethehandsettoinitialize.
NOTE:
IftheswitchisintheincorrectpositionCallerIDandtherecallfunction
will not operate correctly.
 previous next