Oricom BB200 Cordless Telephone User Manual


 
- 8 -
PRE-DAILLING
Pre-dial allows you to enter a telephone number and verify it on the screen before you
place the call. The screen displays the last 12 digits dialled but you can enter up to 2
digits.
In standby mode enter the phone number you wish to dial.
To enter a pause, press the button and a dash “-“will appear in the display.
If you make a mistake, press DEL to erase one digit at a time. Or you can press
and hold the DEL button to clear the entire number and return the phone to standby.
Press to dial out the number.
To end the call, press the button again, or replace the handset back in the base.
Note: If you have connected this phone to an office phone system (PBX) you may need
to enter a pause for a few seconds between dialling the line access code and the
actual phone number.
To pause, press the button and a dash “ - “will appear in the display.
LAST NUMBER REDIAL
You can review and call back the last 3 numbers you have dialled as your cordless
stores them in the redial memory.
In the standby mode press the button to scroll through the last 3 numbers you
dialled.
Select the number you want to redial and press , to dial the number.
CALL DURATION TIIMER
When you make or answer a call the display shows the call duration in time minutes
and seconds.
ADJUSTING THE EARPIECE VOLUME
During a call, to adjust the volume in the handset’s earpiece or speakerphone press
the volume button repeatedly .
The display shows the current volume level: the more “0’s” the highest the volume (“0”
to “00000”).
TO PAGE THE HANDSET
This function is useful if you can’t find your handset.
On the base unit press and release the
button. The handset rings with a special
tone.
To stop the handset ringing, on the handset press any button or numbered key.