Filter
Top Products
10
EN
3. Press to conrm and move to the next setting or press
to conrm the changes and exit the Menu Options. Settings
will automatically be conrmed after 5 seconds if no key is pressed.
SELECT A CHANNEL OR CTCSS
The transmitter and receiver must be on the same channel using the same
CTCSS code in order for you to communicate with another party.
This feature allows you to utilize a less often-used range of CTCSS codes
within a main channel to avoid congestion on the main channel and lter
out unwanted noise and static. There are 38 CTCSS codes for each main
channel.
To select between 8 channels or 38 CTCSS codes:
1. Press once (for channel) or twice (for CTCSS code) until the
corresponding channel / CTCSS number starts ashing.
2. Press and hold
or to change the channel or CTCSS code.
3. Press
to conrm and exit the menu. Or, press to
conrm and go to the next
Menu Option.
NOTE: To communicate with other units that do not have CTCSS code
capability, switch your unit to the same channel and set the CTCSS code
to “0”.
TIP: Before trying to transmit on the selected channel, press to
check the activity on that channel. If someone is already on the selected
channel, try another channel that is clear. To change the basic channel, in
menu mode, press or to move to the next higher or lower channel
number.
P/N:086L004722-016 REV.1 PAGE: 12/152