NuTone Nm100WH Intercom System User Manual


 
MODEL NM100WH
Page 8
APPENDIX A - NUTONE
SYSTEMS
*Refer to frames below:
• NF100MWH – Replacing a master only system with an NM100
master
• NF100CWH – Replacing a combination system with an NM100
master and NC300 CD player
• NF200CWH – Replacing a master only system with an NM100
master and NC300 CD player (requires hole in wall to be made
larger)
• NF300RWH – Used on all indoor remote station replacements
•NF300PWH–Usedonalloutdoororhighsunareaushmount
remote station replacements
• NRKS200PWH – Used on all outdoor surface mount remote
station replacements
•NF300DWH–UsedonolderNuTonedoorstationreplacements,
notrequiredforM&Sreplacements
Afterallconnectionshavebeenmade,inserttheNM100powerplug
into NA300TA transformer and secure the master to the rough-in
usingthe2screwsprovided.IfusingtheNF200CWH,NF100CWH
orNF100MWHframewithaNC300player,installthemasterunit
over the frame. Do not over tighten the screws as the plastic may
distort or crack. Install the speaker panel on the master as shown.
Please be careful to only apply pressure on the speaker panel at
the corners and not in the middle. Check all functions by following
the guidelines in the Owners Manual shipped with the master unit.
Ifanydifcultiesareencountered,recheckallconnections.Ifafter
reviewingtheseinstructionsyouareunabletoresolveanyproblems,
contact technical support at 1-888-336-6151.
TESTING
The door release switch contacts are very versatile and can be
used with many AC/DC door or switch contacts. Be sure to use the
wireandpowersupplyortransformerspeciedbythedoororgate
release product being used.
PANIC INTERFACE WITH SECURITY SYSTEM
Run a lineof 18 gauge solidcopper, twisted pair approvedlow
voltage cable from the NWH300 or NWH300C rough-in location
to the security control panel. Setup the security panel to receive a
normally open dry contact for panic operation. (Refer to programming
procedures accompanying the security panel). Label and secure
cables at the NWH300 or NWH300C rough-in. Have a certied
security installer hook the NM100 up to the alarm system.