Nortel Networks M7310 Telephone User Manual


 
Page 1 Enterprise Edge M7310 User Card
Your Enterprise Edge M7310 Telephone
Using Button
Inquiry
Check what is programmed on your memory buttons.
1. Release all calls or lines with dial tone.
2. Press
ƒ•‚
.
3. Press the button(s) that you want to check and read the display.
4. Press
ƒ
when finished.
Adjusting display
contrast
1. Press
ƒ•‡
.
2. Press
UP
or
DOWN
for the level you want.
3. Press
OK
when finished.
Selecting a ring
type and volume
level
1. Press
ĥfl
.
2. Press
,
¤
,
,
, or
˚NEXT
to hear the different ring types.
3. While the telephone is ringing, press
to adjust the
volume level.
4. Press
OK˚
to store the volume level and ring.
Using display
buttons
Three display buttons appear directly below
the display. When they are active, these
buttons are labelled in capital letters on the
bottom line of the display. In Enterprise Edge
documents, display buttons are shown as
underlined, capital letters: for example,
OK
.
Display
shows the time, date, call information, and guides you.
Indicators
appear beside lines and features.
Feature button
starts or ends a feature.
Release button
cancels active calls.
Hold button
Dial pad
Volume control
Memory and line buttons
are buttons with indicators for one
touch dialing, feature operation
or line access.
The lower line of the display is reserved for display button instructions.
Display buttons
Dual-memory buttons
store any two features and/or autodial numbers.
Shift button
For using the top function of a dual-memory button.
Display button
Show line:_
COPY
Display message
Display button message
OK