Filter
Top Products
Configuring options
19
To pair the Bluetooth Headset with your phone:
1. Check with your administrator to ensure that Bluetooth is available for
your use.
2. Restart your IP Phone 1140E using one of the following methods:
• If you are using an AC power adapter, unplug it, wait 10 seconds, and
reinsert it.
• If you are using Power Over Ethernet (POE), unplug the LAN
Ethernet cable, wait 10 seconds, and reinsert it.
3. Double-press the key access 3. Bluetooth setup.
The Enable Bluetooth check box is highlighted.
Note: If the Bluetooth Setup item appears dimmed, then your phone
is not configured to support a Bluetooth headset; contact your system
administrator.
4. Press the Enter key to activate Bluetooth.
A check mark is displayed to indicate that Bluetooth is activated. The
message “BT Enabled” appears at the bottom of the display.
5. Put your Bluetooth headset in its pairing or search mode. The
procedure for doing this can be different for each Bluetooth headset.
Refer to the documentation that accompanied your headset, or
contact the vendor.
For example, if you are using the GN Netcom GN 6210, do the
following:
a. Turn the headset off by pressing and holding the telephone
button for 3 - 4 seconds until a high to low tone is heard. The
headset blue LED turns off.
b. Press and hold the telephone button for about 8 seconds until
the blue LED flashes and then lights steadily.
6. Search for (pair) the headset:
a. Press the Right navigation key one or more times until the
Search button is shown next to the Search Devices item.
b. Press the Enter key.
The message "Searching…." is displayed.