Filter
Top Products
Connecting the components
32
Figure 7: Cable routing tracks and mounting holes
8. Wall-mount your phone (optional). Your IP Phone 1120E can be
mounted either by: (Method A) using the mounting holes on the
bottom of the phone stand, or (Method B) using a traditional-style
wall-mount box with an RJ-45 connector and a 15-cm (6-inch) RJ-45
cord (not provided).
Complete steps 1-7, as needed, before you wall-mount your phone:
Method A: Press the wall-mount lever, and pull the phone away from
the stand, as shown in Figure 5 on page 29.Using the stand cover
(the part you removed in step 1), mark the wall-mount holes by
pressing the bottom of the stand cover firmly against the wall in the
location where you wish to install the phone. Four small pins on the
bottom of the stand cover make marks on the wall. Use the marks as
a guideline for installing the wall-mount screws (not provided). Install
the screws so that they protrude 3 mm (1/8 inch) from the wall, and
then install the phone stand mounting holes over the screw heads.
You may need to remove the phone from the wall to adjust the lower
screws. When the lower screws are snug, install the phone on the
mounting screws, and then tighten the top screws. See Figure 7 on
page 32.