Filter
Top Products
ND-45503 (E) CHAPTER 3
Page 25
Revision 2.0
CHAPTER 3 DATA PROGRAMMING SHEETS
1. GENERAL
This chapter provides the System Data Sheets for programming the Customer Specifications in Chapter 2. For
the programming method and the detailed information on the commands, refer to the Command Manual.
In the Programming sheets, the meanings of markings are as follows:
: Initial Data
With the system data clear command (CM00, CM01), the data with this marking is automatically as-
signed for each command.
In the programming sheets, initial data, which are automatically loaded into the memory after system initializa-
tion, are indicated with “ .” Therefore, the installer should confirm the meaning of initial data, and change or
delete the data, if required.
: System Initialization
After entering the data, a system reset is required (Depress SW1 of the MP card).
: MAT Mode
If there is a abbreviation under the command code designation, then programming can
be accomplished by the MAT mode of programming instead of the MOC mode or CAT mode.
INITIAL
MAT
MAT