Filter
Top Products
ND-45503 (E) CHAPTER 1
Page 3
Revision 2.0
4.DATA PROGRAMMING PROCEDURE
Table 1-1 shows the procedure and the outline of the work related data programming for the system.
The various data programmed in this manual are entered into the system through the CAT/MAT.
Table 1-1 Data Programming Procedure
STEP WORK REMARKS
1. Obtain the customer’s requirements, and fill in the
Customer Specification Sheets on Chapter 2.
2. Allocate the LC, TRUNK and other interface cards to
the Port Assignment Table on Chapter 2. Make a Bay
Face Layout on Chapter 2 for accommodating cards
required in the system.
3. Fill in the data programming sheets on Chapter 3 with
the Customer Specification Sheet, Port Assignment
Table and Bay Face Layout completed as steps 1 and
2.
For the programming method and the detailed
information on the Command, refer to the Command
Manual.
4. Ensure that the data on all programming sheets are
correct and consistent with customer specifications.
5. Specify the switch setting on the boards with the
Switch Setting Table in the Circuit Card Manual.
For the function of each switch on the cards, refer to
the Circuit Card Manual.