Filter
Top Products
32
Direct Paging - Handsfree Answerback Disabled
Your administrator enables or disables Handsfree Answerback and you can also turn it on or off
on your phone.
To turn Handsfree Answerback off, see "Direct Paging – Handsfree Answerback Enabled"
elsewhere in this guide. When Handsfree Answerback is disabled on your phone and you receive
a Direct Page, the Direct Page is indicated by a single burst of tone.
To answer Direct Page calls when Handsfree Answerback is disabled:
Phone state before Page
arrives:
To answer the Direct Page (indicated by single burst of tone):
Phone is idle and MUTE is
OFF.
1. Check that MUTE is ON solid. 2. Lift the handset OR press
MUTE key to answer in Handsfree mode. (The light turns OFF.)
3. Begin speaking.
You are on a handset call or
headset call, and MUTE is
OFF
1. Check that MUTE is flashing. 2. Press MUTE. The light turns
ON solid and and you are now speaking to the paging party and
have MUTED your handset/headset call. 3. Speak to the paging
party. Press MUTE to alternate between handset and handsfree
calls.
You are on a MUTED
handset/headset call, OR, you
are on a Handsfree call
The party paging you receives a busy tone. Handsfree Answerback
does not interrupt your call.
To end a Direct Page call, do one of the following:
• Hang up the handset to end a handset call.
• Press
( SPEAKER ) to end a Handsfree call.
• Press ( CANCEL ).
Note: When the Handsfree Direct Page call ends, the (MUTE) key light returns to the state it was
in before the call was established.
Reminder (5224 IP Phone only)
To program a Reminder:
1. Press ( SUPERKEY ).
2. Press the No softkey until "Timed Reminder?" appears.
3. Press the Yes softkey.