NEC 5224 IP Phone User Manual


 
31
When your phone is idle, press
(MUTE) once. The MUTE key light flashes to
indicate that Handsfree Answerback is ON.
When a Direct Page arrives, the MUTE key light turns OFF and a Handsfree call is
automatically established.
To turn Handsfree Answerback off:
Press the flashing (MUTE) key once. The MUTE key light turns OFF.
To respond to a Direct Page when Handsfree Answerback is OFF, see "Direct Page –
Handsfree Answerback Disabled" elsewhere in this guide.
Note: By default, Handsfree Answerback is turned OFF at your phone. If the
(MUTE) key is
OFF when your set is idle, Handsfree Answerback is OFF.
To answer a call using Handsfree Answerback:
Phone state before Page
arrives
To answer the Direct Page
Phone is idle and MUTE is
flashing
1. Check that MUTE is OFF. 2. Listen for the paging party. 3.
Begin speaking. 4. Lift the handset if you wish to switch from a
Handsfree call to a handset call.
You are on a handset or
headset call, and MUTE is
OFF
1. Check that MUTE is flashing. 2. Press MUTE. The light turns
ON solid, and you are now speaking to the paging party and have
muted your handset/headset call. 3. Speak to the paging party.
Press MUTE to alternate between handset/headset and handsfree
calls.
You are on a MUTED
handset/headset call, OR,
you are on a Handsfree call
The party paging you receives a busy tone. Handsfree Answerback
does not interrupt your call.
To end a Handsfree Answerback call:
Press either
( SPEAKER ) or ( CANCEL ).
Note : When the Handsfree Direct Page call ends, the MUTE key light returns to the state it was
in before the call was established.