Filter
Top Products
13
Below are the steps to the ‘Caller ID’ setting. The same procedures are used for
‘Prompt’ and ‘Power-Save’.
Press and release the Talk Button, say “Setup Menu”, then say “Caller ID”. MV900
will prompt the current mode (ON or OFF). If you say “Yes”, the MV900 will keep
the current settings and the voice prompt will repeat “Set Up”. If you say “No”, the
MV900 will toggle and prompt next option. When you have heard the one you
want, say “Yes” to save.
Setup Option Commands in Setup Menu
Prompt ON Voice prompt announcement for an easier operation
OFF
No voice prompt for a faster operation. Recommend for
experienced users after becoming familiar with all commands.
Caller ID ON
Says the Caller ID for all incoming calls
OFF
Does not say the Caller ID for incoming calls
Power-Save ON
Enable the power save mode while in Bluetooth (This might
create connection lost issue since many Bluetooth phones
do not support this mode)
OFF Disable the power saved mode, this will guarantee Bluetooth
connection. Factory setting is set to OFF.
Table for numbers stored in MV900’s memory
Number Type Number Extension
Home
Work
Voicemail Home
Voicemail Work
Voicemail Cell Phone
Memory 1
Memory 2
Memory 3
Memory 4
Memory 5
Memory 6
Memory 7
Memory 8
Memory 9