Memorex MPH6935 Cordless Telephone User Manual


 
33
Additional Information
(continued)
1 Insert two mounting screws into the
wall, (with their appropriate anchoring
device), 3-15/16 inches apart. Allow
about 1/8 of an inch between the
wall and screw heads for mounting
the phone.
2 Refer to steps 1 through 5 above to
mount the telephone.
[Direct wall plate mounting]
If you don't have a standard wall plate, you can mount your phone directly to the wall.
Before doing this, consider the following:
Avoid electrical cables, pipes, or other items behind the mounting location. That
could cause a hazard when inserting screws into the wall.
Try to mount your phone within 5 feet of a working phone jack to avoid excessive
cord lengths.
Make sure the wall material is capable of supporting the weight of the base
and handset.
Use #10 screws (minimum length of 1-3/8 inches) with anchoring devices suitable
for the wall material where the base unit will be placed.
1 Plug the telephone line cord to the
TEL LINE jack and the AC adapter to
the DC IN 9V jack.
2 Plug the telephone line cord into the
telephone outlet.
3 Place the AC adapter cord inside the
molded wiring channel.
4 Plug the AC adapter into a standard
120V AC wall outlet.
Note
Use only the AC adapter
supplied with this phone.
5 Align the mounting slots on the base
with the mounting posts on the wall.
Push in and down until the phone is
firmly seated.
Mounting the base unit on a wall
Standard wall plate mounting
This phone can be mounted on any standard telephone wall plate.
5
5
2
4
3
1
MPH6935_OM Eng 3/12/02 3:08 PM Page 33