Filter
Top Products
4
Installation
Charging the Battery Pack
The rechargeable Nickel-Cadmium battery pack must be
fully charged before using your phone for the first time.
Before plugging the phone line into your new
phone, you must charge the battery for
approximately 15-20 hours without interruption.
1. Remove the handset battery cover.
2. Plug the battery’s cable into the handset.
The plastic connectors will fit together only
one way. Make sure the battery’s connector is
properly aligned. Use only the battery pack
(model BT-904) supplied with your phone.
3. Replace the battery cover.
▼ Charging the Handset
Place the handset on the
base to charge. (Place the
handset upright in the
charging cradle with the
keypad facing forward.)
▼ Low Battery Indicator
When the battery pack in the
handset is low and needs to be
charged, the TALK/BATT LED
flashes every 3 seconds.
If this occurs while you are on the phone, you will hear a
tone. Complete your call as quickly as possible, and return
the handset to the base for charging.
▼ Cleaning the Battery Contacts
To maintain a good
charge, it is important
to clean all battery
contacts on the handset
and base about once a
month. Use a pencil
eraser or other contact
cleaner. Do not use
any liquids or solvents.
Selecting a Location
Before choosing a location for your new phone, read the
“Installation Considerations” included in the “Precautions
and Important Safety Instructions”.
Important: Do not place the power cord in an
area where it may create a trip hazard or become
chafed and create a fire or electrical hazard.
Choose the Dialing Mode
1. Press and hold FLASH until you hear a confirmation tone.
2. To set the dial mode for pulse dialing, press #.
Or to set the dial mode for tone dialing, press
✱/TONE. A confirmation tone sounds to indicate the
setting is complete.
Make sure your battery pack is fully charged
before choosing the dial mode.
3
1
2
Contacts
UC372BH (MPH6925) OM ENG 3/12/02 11:24 AM Page 4