Filter
Top Products
User Manual S5
Page 12
English
If a conversation is detected on any of the channels in the scan list, the radio will stop on that
channel and you will be able to hear the conversation.
If programmed for normal scan TX, you will be able to transmit on that active channel during the
programmable scan delay time. (The scan delay time is the amount of time the radio will stay on
that channel once activity has ceased. Dealer programmable, 4-7 seconds is typical). The radio
will resume scanning once the scan delay time has expired, and will continue to scan until the
channel is changed. The LED will flash green.
When in scan mode, if power is switch off and on, the radio reverts back to "scanning"
automatically.
Nuisance Scan Delete
If there are any unwanted signals on any of the channels being scanned, they can be temporarily
removed from the scan list. When the scanning feature has locked onto the unwanted signal
simply press the monitor button. this will delete that channel from the scan list. When the radio is
switched off and back on the channel is restored in the scan channel list.
Priority Channel Scan
A single channel may be programmed as the "Priority" channel. The radio will constantly monitor
this channel while scanning. If a call is detected on the priority channel, the radio will
automatically move to, and remain on, the priority channel activity takes precedence over all
other conversations.
Fixed Key
PTT (Press to Talk)
1. Press and Hold to transmit. Release to enter the receive mode.
2. Power on with press and holding PTT Key to see software version.
MONITOR
Releases the squelch and tone circuit to check whether the channel is busy.
OPTION
Short pressing: Enable/disable scan
Look Back channel edit
EMG
Transmits EMG ID 5 times and generate warning audio alert for a duration of 7 secs.
English