Filter
Top Products
IB-PH559(9803F)-WM-E-090103
Volume Control and Ringer Setting
Slide the HANDSET VOLUME control (LOUD or NORMAL).
Adjust the handset volume
Adjust the ringer ON
or OFF
Set RINGER ON/OFF switch.
ON - Normal setting, the phone rings on incoming calls.
OFF - To turn off the ringer, for undisturbed privacy.
NOTE: Only this phone will not ring, other phones on the
same line will continue to ring normally.
If you have subscribed to the Caller ID service, the callers number and/or name appears on
the display when you received a call (see page 11).
1. Pick up the HANDSET or press the SPEAKERPHONE button. The hook icon will
show in the display.
2. Press the REDIAL/PAUSE button. The last dialed number appears in the display and is
automatically dialed.
Last Number Redialing and Pause Function
TO CHECK THE LAST PHONE NUMBER DIALED
While the handset is on the base, press the REDIAL/PAUSE button. The number appears
in the display for 3 seconds.
NOTE: If the last dialed number exceeds 16 digits, only 16 digits will be displayed.
PAUSE FUNCTION
Example: In an office where you need to dial a 9 first to get an outside line.
Dial the number 9 and press REDIAL/PAUSE button, and then dial the phone number. You
will see a displayed for pause. You may also store this into memory.
9
Hands-Free (Speakerphone) Operation
ANSWERING CALLS WITH THE SPEAKERPHONE
1. After the phone rings twice, press the SPEAKER button, the SPEAKERPHONE
INDICATOR will light, and the hook icon will show in the display.
2. The display will show the Count Up Call Timer after a few seconds.
3. Adjust the speakerphone volume by sliding the SPEAKER VOLUME control on the right
side of the phone.
4. To end the call, press the SPEAKER button again.
5. The SPEAKERPHONE INDICATOR will go off and the display will return to Time and
Date mode.
MAKING CALLS WITH THE SPEAKERPHONE
1. Press the SPEAKER button to get a dial tone - no need to lift the handset.
2. The SPEAKERPHONE INDICATOR will light and the hook icon will show in the
display, the Count Up Timer will start after a few seconds.
3. Adjust the speakerphone volume by sliding the SPEAKER VOLUME control on the right
side of the phone.
4. Dial your call.
5. To end the call, press the SPEAKER button again.
6. The SPEAKERPHONE INDICATOR will go off and the display will return to Time and Date
mode.
NOTE: When pick up the HANDSET or press the SPEAKER button, the hook icon will
show in the display. If this icon shows in the display while the phone is not in use,
remember to check if the HANDSET is replaced properly or the SPEAKER button is
pressed to off.