IB-PH5562-WM-E-010807
WALL MOUNTING
1.HANDSET CLIP - When the phone is mounted on the wall, the HANDSET CLIP must be
adjusted so it will hold the HANDSET.
A. SLIDE OUT B. REVERSE C. REPLACE INTO PHONE
NOTE: For either desk use or wall mounting, you need to install the included adaptor correctly.
If you do not have a modular wall phone plate installed, please consult with your phone
company or installer to get one.
2.Put the straight telephone line cord into the wall adaptor, leave one end of the telephone
line cord about 7” and the other end about 3”.
4.Plug the longer wire about 7” into the top of the phone, plug the 3” wire into wall jack.
ABOUT 7 INCHES
(plug into phone jack)
ABOUT 3 INCHES
(plug into wall jack)
3.Install the wall adaptor on the bottom of
the base as the diagram on the right.
5.Put the phone over the wall plate, make sure both posts fit into slots on the back of
the phone. Then slide the phone down to lock the phone onto the wall plate.
8
IB-PH5562-WM-E-010807.pmd1/23/2007, 5:08 PM9
PDF created with pdfFactory Pro trial version www.pdffactory.com