Filter
Top Products
The DELETE button must be quickly pressed twice
to erase a single call record. To erase ALL call
records, display any record using the UP or DOWN
button, then press and hold the DELETE button
for about 6 seconds.
CHECK
NOTE :
1. If problems with your telephone service occur later, try to determine if the trouble is with
the telephones you own or with the telephone company equipment. Unplug the tele-
phone and try it on another jack in a different room or in a neighbors home to see if the
phone line is bad or the phone.
If the known working phone does not operate properly on that line, contact your local
telephone company for assistance.
2. If disconnection of your phone ends the problem, your phone may be the source of the
trouble and it should be tested and repaired if necessary before it is re-connected.
3. There are no user maintainable parts or adjustments on this set. Should your phone
require repairing, contact the manufacturer for instructions (except for cords which you
can buy at any phone store).
Check with your telephone company if this service
is available and if you have subscribed for it.
The caller may have an unlisted or blocked num-
ber to prevent Caller ID identification, or it may be
an overseas call or you may have noise on the
line during that call.
You picked up the phone before the second ring,
or your phone received unclear call information.
Static can cause this message.
If this condition persists, contact your local tele-
phone company to ensure that there is no prob-
lem with your phone line.
Handset clip was not installed properly for wall
use. See page 13 for details.
16
TROUBLE SHOOTING (continued)
appears on the display
Cannot erase all records in memory
Caller ID displays words like
,
or or or
.
Your language is set for French or Spanish. To
reset the language, press and hold the DELETE
button down, the display will go to the contrast
level setting, press delete again then press the
DOWN button. When
is flashing, press DE-
LETE button to confirm. The language will be set
to English mode.
Check if you have stored the numbers correctly
by pressing that memory location button(s). Also
numbers can only be stored when fresh batteries
are installed correctly.
Memory Dialing does not work
Handset falls out of phone base when wall
mounted
Callers information is not registered to the
Caller ID memory
Call Waiting or Message Waiting does not
work
Pressing a Memory button does not
display number
Your MEMORY button has no stored number.
Please store the number again. Press the STORE
button, dial the number and press the MEMORY
locations you want.
PROBLEMS
Call waiting does not show the number
If an extension phone was pickup up on call 1,
this phone will not decode the call waiting, Caller
ID signals, if the extension phone is not a call
waiting caller ID phone.
PH-549042100RTTv.2 E