Filter
Top Products
Mounting the Phone on a Wall Plate our Wall
If you prefer a wall-mounted phone to a desktop phone, you can mount the phone on
a wall plate or directly on a wall.
Attach the mounting bracket to the bottom of the phone so there is a second keyhole
slot for wall mounting. Remove the handset from its cradle and turn the phone upside
down. Inset the two smaller tabs into the slots shown in figure 3, then press down on
the bracket’s bottom edge until the two larger tabs snap into place.
Note: If the large tabs do not snap in easily, push slightly against the tabs while you press
down on the bracket.
Follow these steps to mount the phone on a wall plate. See Figure 3
1. Plug one end of the
supplied short telephone
cord into the jack on the
back of the base.
2. Plug the other end of the
cord into the wall plate
jack, then fit the keyhole
slots over the wall plate
studs and slide the base
downward to secure it.
3. Before you hang up the
phone’s handset, slide up
the handset holder to
remove it see figure 6.
Turn over the handset holder so its tabbed edge
faces up, and then slide it back down into its slot.
Note: To mount the phone directly on a wall, you
need two screws (not supplied) with heads
that fit into the keyhole slots on the bottom of
the base.
Follow these steps to mount the phone directly on a wall.
1. Drill two holes 3 15/16 inches (100 mm) apart. Then thread a crew into
each hole, letting the heads extend about 1/8 inch (3.5 mm) from the
wall. See Figure 5
Handset Holder
4
.Figure 3
.Figure 4