Filter
Top Products
- 7 -
t
Press the button, till the
desired language appears in the
display window.
2^
Press the button, to save
the selected setting.
If this function is not presented automa-
tically – or, if you wish to once again call
this function at a later point of time:
This can be done through the program-
ming mode as described under Section 8.
b) Allocating the memory capacity
This function, as described here, will
appear only when starting the opera-
tions in a new phone – it cannot be
recalled later! However, you can call
this function only by removing the
batteries for more than 10 minutes.
In such case, all entries in the Phone
Book and other settings are lost.
Phone Book and Incoming call list share
a common memory area. The following
memory allocation is preset at factory:
– 32 entries for the Phone Book:
– 65 entries for the Incoming call list
Using this function, you can change the
memory allocation between Phone Book
and Incoming call list:
Phone book: Max. 112 entries
Incoming call list: Max 91 entries
t
For this, press the button to
change the number of entries for
the Phone Book. If you...
– decrease the preset number, the
Incoming call list will be increased
by a corresponding number,
– increase the preset number, the
Incoming call list will be decreased
by a corresponding number.
Setting the Phone Book size alone is
enough to achieve this. As this concerns
the memory allocation, any changes
made for one of the two numbers will
affect the other number.
2^
Press the button, to save the
settings.
9. Basic settings
The functions described here are only
accessible in the programming mode.
To call the programming mode,...
2@
hold the button for at least
3 seconds while the receiver is
on hook. Now the display starts
blinking with the selected language.
2@
Each time you press the you can
scroll through all setting options.
To terminate the programming mode, ...
2^
press the button twice, or...
• refrain from operating any button
for more than 10 seconds. The phone
will return to the normal operating
state.
a) Changing the display language
If you have called the programming
mode, first the set language will start
blinking in the display window. You
can change this as described under
7.a).
e-bench KH 5001
IB_KH5001_UK 09.07.2007 15:38 Uhr Seite 7