Filter
Top Products
- 10 -
a
For saving the changes and to termi-
nate the function, press the but-
ton twice.
When you press the button once the
text "LINE IN USE" is displayed: If you
press it again, the phone is again rea-
dy for operation.
Using the switch "RING L/H"
2(
addi-
tionally the ringer volume can be set
to 1 (L) and the previously set volume
(H).
i) Setting the dialling mode
Today many telephone sets are capable
of transmitting the dialled number
through Tone dialling mode to the
service provider or to the PABX. Only
the older machines still have the Pulse
dialling mode:
– The Tone dialling can be identified
while dialling by its double tone in
the receiver.
– The Pulse dialling can be identified
while dialling by its typical "beats"
in the receiver.
The dialling mode is automatically set
by the telephone: The dialling mode
selected after connecting to the line
will be stored.
j) Changing the dialling mode
As against the above-described function,
you can change between the dialling
modes. This is useful if, for example,
your PABX requires a Pulse dialling
mode, but you may need to use the
Tone dialling mode for certain other
services:
i
Press and hold the button when
the receiver is on hook. In the display
window the following alternating
messages appear:
"DIAL IN PULSE" – pulse dialling is
enabled,
"DIAL IN TONE" – tone dialling is
enabled.
i
Release the , button if the desired
dialling mode is displayed.
10.Making a phone call
When the phone is connected correctly
and you can hear the dial tone on pik-
king up the receiver:
a) Receiving phone calls
To receive an incoming phone call...
• Pick up the receiver off the hook or...
a
press the button. This enables
the hands-free mode. When the
hands-free mode is on, you can
pick up the receiver off the hook
and listen to the call.
b) Terminating phone calls
To terminate incoming and outgoing
calls...
• Place the receiver on the hook or...
a
press the button, again when
the hands-free mode is on.
e-bench KH 5001
IB_KH5001_UK 09.07.2007 15:38 Uhr Seite 10