Honeywell 2020 Cordless Telephone User Manual


 
4 - 5
Intercharacter Delay
An intercharacter delay of up to 495 milliseconds may be placed between the
transmission of each character of scanned data. Scan the Intercharacter
Delay barcode below, then scan the number of milliseconds and the SAVE bar-
code using the Programming Chart inside the back cover of this manual.
To remove this delay, scan the Intercharacter Delay barcode, then set the num-
ber of steps to 0. Scan the SAVE barcode using the Programming Chart inside
the back cover of this manual.
Note: Intercharacter delays are not supported in USB serial emulation.
User Specified Intercharacter Delay
An intercharacter delay of up to 495 milliseconds may be placed after the trans-
mission of a particular character of scanned data. Scan the Delay Length bar-
code below, then scan the number of milliseconds and the SAVE barcode using
the Programming Chart inside the back cover of this manual.
Next, scan the Character to Trigger Delay barcode, then the 2-digit hex value
for the ASCII character that will trigger the delay ASCII Conversion Chart (Code
Page 1252) on page A-2.
To remove this delay, scan the Delay Length barcode, and set the number of
steps to 0. Scan the SAVE barcode using the Programming Chart inside the
back cover of this manual.
1 2345
Intercharacter Delay
Prefix Scanned Data Suffix
Intercharacter Delay
Delay Length
Character to Trigger Delay