Filter
Top Products
13.Never install telephone jacks in wet locations unless the jack is specifically
designed for wet locations.
14.Never touch uninsulated telephone wires or terminals unless the telephone
line has been disconnected at the network interface.
15.Use caution when installing or modifying telephone lines.
16.Avoid using this equipment during an electrical storm.
There may be a remote risk of electric shock from lightning.
17.Do not use this equipment to report a gas leak in the vicinity of the leak.
Federal Communications Commission Part 68 - Equipment Statement
This equipment complies with Part 68 of the FCC Rules. On the bottom of this
equipment is a label that contains, among other information, the FCC Registration
Number, Ringer Equivalence Number (REN), and USOC jack type for this
equipment. If requested, this information must be provided to your telephone
company.
An FCC compliant telephone cord and phone jack is provided with
this equipment. This equipment is designed to be connected to the telephone
network or premises wiring using a compatible phone jack which is Part 68
compliant. See installation instructions for details.
The REN is used to determine the quantity of devices which may be connected to
the telephone line. Excessive REN's on the telephone line may result in the
devices not ringing in response to an incoming call. In most, but not all areas, the
sum of the REN's should not exceed five (5.0). To be certain of the number of
devices that may be connected to the line, as determined by the total REN's
contact the telephone company to determine the maximum REN for the calling
area.
If this equipment HPW-200EC causes harm to the telephone network, the
telephone company will notify you in advance that temporary discontinuance of
service may be required.
But if advance notice isn't practical, the telephone company will notify the
customer as soon as possible.
Also, you will be advised of your right to file a compliant with the FCC if you
believe it is necessary.
4