Filter
Top Products
FIRMWARE VERSION 1.0.3.1 HT70X USER MANUAL Page 44 of 52
TABLE 12: HT704 FXS PORTS SETTINGS
SIP Use ID
User account information, provided by VoIP service provider (ITSP). Usually in the form
of digit similar to phone number or actually a phone number.
Authenticate ID
SIP service subscriber’s Authenticate ID used for authentication. Can be identical to or
different from SIP User ID.
Password
SIP service subscriber’s account password for HT704 to register to (SIP) servers of
ITSP.
Name
Any name to identify this specific user.
Profile ID
Select the corresponding Profile ID between Profile 1 and Profile 2.
Hunting Group
This feature enables the HT704 to register all existing FXS ports with the same phone
number. Each incoming call will be routed to first available port in Linear or Circular
mode. User may configure all ports as members of the same Hunting Group or it may
configure different port combinations for more than one Hunting Group. For example:
Ports 1, 3 and 5 are members of the same Hunting Group, the rest of the ports may
have separate numbers and may be reached independently. Any port, member of a
Hunting Group that is not registered with a SIP account, will be able to place outbound
calls using the SIP credentials of the primary Hunting Group port.
For example: Port 1, 2, and 3 are members of the same Hunting Group. Port 1 is
registered with a SIP account. Ports 2, and 3 are not registered. Ports 2 and 3 will be
able to place outbound calls using the SIP account of port 1. Select appropriate value
for Hunting Group feature. The original SIP account should be set to Active while the
group members should be set to the port number of the Active Port.
Example configuration of a Hunting group:
FXS Port #1: SIP UserID and Authenticate ID entered, Hunting group set to "Active"
FXS Port #2: SIP UserID and Authenticate ID left blank, Hunting Group set to "1"
FXS Port #3: SIP UserID and Authenticate ID left blank, Hunting Group set to "1"
FXS Port #4: SIP UserID and Authenticate ID entered, Hunting group set to "None"
Hunting Group 1 contains ports 1, 2, 3. FXS port 4 is registered but it is not added to
the Hunting Group 1.
Enable Ports
Set No to disable FXS port.
Offhook Auto-dial
This feature allows you to automatically dial the number specified in this field as soon
as the port is offhooked, i.e. when the receiver on the phone connected to Port# is
picked up.
Map to FXP Port #
This is used only when peering with a Grandstream GXW410x. Default is 1, Supported
values are 1-8, meaning line 1 to line 8 of the GXW410x device where the port will be
mapped to.
Map to FXO Gateway IP
This is used when peering with an FXO gateway of any brand. You have to specifically
mention the IP address where the call will be sent to.