Filter
Top Products
Grandstream Networks, Inc. HT-502 User Manual Page 19 of 32
Firmware 1.0.0.77 Last Updated: 1/2008
TABLE 8: HT502 BASIC CONFIGURATION SETTINGS DEFINITIONS
End User Password
Password to access the Web Configuration Menu. This field is case sensitive with a
maximum length of 25 characters.
Web Port
By default, HTTP uses port 80. This field is for customizable web port.
Telnet Server
Default is set to YES.
IP Address
There are two modes to operate the HT502:
DHCP mode: all the field values for the Static IP mode are not used (even though they
are still saved in the Flash memory.) The HT502 acquires its IP address from the first
DHCP server it discovers from the LAN it is connected. Using the PPPoE feature: set the
PPPoE account settings. The HT502 will establish a PPPoE session if any of the PPPoE
fields is set.
Static IP mode: configure the IP address, Subnet Mask, Default Router IP address,
DNS Server 1 (primary), DNS Server 2 (secondary) fields. These fields are set to zero by
default.
DHCP hostname Default is blank. This option specifies the name of the client. This field is optional but may
be required by some Internet Service Providers.
DHCP domain Default is blank. This option specifies the domain name that client should use when
resolving hostnames via the Domain Name System.
DHCP vendor class ID Default is HT500. Used by clients and servers to exchange vendor-specific information..
PPPoE account ID
PPPoE username. Necessary if ISP requires you to use a PPPoE (Point to Point Protocol
over Ethernet) connection.
PPPoE password
PPPoE account password.
PPPoE Service Name Default is blank. This field is optional. If your ISP uses a service name for the PPPoE
connection, enter the service name here.
Time Zone
Controls how the date/time is displayed according to the specified time zone.
Self Defined Time Zone The syntax is std offset dst [offset],start[/time],end[/time]
Default is set to : MTZ+6MDT+5,M3.2.0,M11.1.0
MTZ+6MDT+5,
Time zone with 6 hours offset with 1 hour ahead which is the US central time. It is positive
(+) if the local time zone is west of the Prime Meridian and negative (-) if it is east.
Prime Meridian (a.k.a: International or Greenwich Meridian)
M3.2.0,M11.1.0
The 1
st
number indicates Month: 1,2,3,..,12 (for Jan, Feb, .., Dec)
The 2
nd
number indicates the n
th
iteration of the weekday: (1st Sunday, 3rd Tuesday etc)
The 3
rd
number indicates Weekday: 0,1, 2, ..,6(for Sun, Mon, Tue, .., Sat)
Therefore, this example is the DST which starts from the second Sunday of March to the
1st Sunday of November.
Language
Languages supported with voice prompt.
Device Mode
This parameter controls whether the device is working in NAT router mode or Bridge
mode. Save the setting and reboot prior to configuring HT502.