Filter
Top Products
43
Appendix
Gigaset 4010 Classic, GBR, A31008-G4010-J101-1-7619
anha.fm
12.07.01
Appendix
Maintenance
Simply wipe the base station and handset with a
damp cloth
or an
antistatic wipe.
Never
use a dry cloth as this can cause static dis-
charge!
Troubleshooting
If your telephone does not behave the way you want it to, first try to
solve the problem using the following list.
Fault Possible cause Solution
No
display.
Handset not
activated
Hold
down
the end call
key
for 1 second
Batteries empty Charge or replace the
batteries (see page 7).
No reaction to key-
stroke.
Keypad protection
activated
Hold
down
the
4
key
for
1 second
No radio connec-
tion to the base
station – all dis-
plays flashing.
Handset outside the
base station range.
Move closer to the base
station.
Handset not
registered
Register the handset
(see page 27).
Base station not acti-
vated
Check the connector at
the base station (see
page 6).
Handset that is in
the base station is
not charging.
Line seized by a sec-
ond handset for a
long period.
Maximum charging pow-
er is only possible while
nobody
is
making calls.
Handset/base sta-
tion does not ring.
Ringer off Activate the ringer
(see page 36/page 40).
Your caller on the
telephone cannot
hear you.
The key was
pressed – the micro-
phone is “muted”.
Press
to
re-activate the micro-
phone.
The incoming call
number is not dis-
played although
CLIP is set.
The telephone
number transmis-
sion
is blocked.
Callers must permit the
transmission of their tele-
phone numbers at their
network providers.
,17 *2%$&. 2.