Filter
Top Products
20
STORING CID RECORDS IN MEMORY
1. Make sure the phone is OFF (not in talk mode).
2. Press the CID-VOL (- or +) button on the handset until the desired CID
record is displayed.
3. Press the memory button on the handset.
4. Press a number key (0-9) on the handset to store the CID information in
that memory location. You will hear a confirmation tone.
NOTE: If the memory location is occupied, REPLACE MEMO? is displayed,
and you must confirm replacement by pressing the memory button.
STORING A REDIAL NUMBER
1. Make sure the phone is OFF (not in TALK mode).
2. Press the memory button on the handset.
3. Press any number key (0-9) on the handset to store the phone number
in that memory location.
4. Press memory again, and
ENTER NAME
shows on the display.
5. Use the handset touch-tone pad to enter the caller’s name (see step 4 in
Storing A Name and Number in Memory), and then press memory
again.
ENTER TEL NUMBR
displays.
6. Press redial on the handset to display the redial number and name.
7. Press memory again to confirm.
NOTE: If the redial number has more than 24 digits, the redial number
cannot be stored in memory.
To replace an old redial number stored in a memory location with a new
redial number:
1. Repeat steps 1 through 5, then press redial to display the new redial
number and name.
2. Press memory again, and
REPLACE MEMO?
shows in the display.
NOTE: You must press the memory button to confirm replacement.