Filter
Top Products
16
FACTORY DEFAULT
As you become familiar with this system, you may prefer to use the
system’s original settings. Follow the steps below to return to the factory
default settings.
1. Press the flash/prog button until
DEFAULT
shows in the display. The
default is
NO
.
2. Use the CID-VOL (- or +) buttons to select
YES
or
NO
.
3. Press the flash/prog button again. You will hear a confirmation tone.
NOTE : The default settings are ENGLISH, AREA CODE - - -, and RINGER
TONE 1.
NOTE : Press the *exit button once to keep the previous setting and return to
the standby screen.
TELEPHONE OPERATION
MAKING A CALL
1. Pick up the handset, and press the talk/callback button.
2. When you hear a dial tone, dial a telephone number.
3. When finished, press the talk/callback button again to hang up.
OR
1. Dial the phone number first, then press the talk/callback button.
2. When finished, press the talk/callback button again to hang up.
NOTE: If you make a mistake press the del/chan button to backspace and
erase the wrong number(s).
ANSWERING A CALL
1. Pick up the handset, and press the talk/callback button.
NOTE: The talk/callback button is disabled when the handset is in
the cradle.
2. When finished, place the handset back in the cradle, or press the talk/
callback button again.
IMPORTANT: Because cordless phones operate on electricity, you should
have at least one phone in your home that isn’t cordless in the event of a
power failure.