Filter
Top Products
English
8
Out of memory
The memory has room for up to 59 messages (including the outgoing message) max. 15 minutes (the
NeoBio 15r) or 30 minutes (the NeoBio 25r) depending on the compression you set. When TAM FULL is
shownorthebaseunitashesFF, no new messages can be recorded until the old ones have been played
back and deleted. In that case, the telephone answer machine responds with the outgoing message for
Answer Only.
PLEASE NOTE!
Remember to delete messages regularly!
Answer machine settings
1. Press . Scroll to ANS. MACHINE. Press OK.
2. Scroll to TAM SETTINGS. Press OK.
3. Scroll to desired function. Press OK.
4. Scroll to desired setting. Press OK.
ANSWER MODE Choose between ANSWER & REC and ANSWER ONLY (caller cannot leave message).
TAM LANGUAGE Select language for pre-recorded outgoing message. To activate this, press
C
(right menu
button) during playback of outgoing message.
OGM SETTINGS Record/listen to outgoing msg.
ANSWER DELAY Select after how many rings (2,4,6,8, time saver*) the call will be answered.
RECORD TIME Select maximum recording time for each msg.
REMOTE ACC. Select remote access off/on.
COMPRESSION Higher compression gives longer recording time but reduced sound quality, LOW = best
sound quality but about half memory capacity.
BS SCREENING Enable/disable the function in base unit which is described in chapter Screening.
CHANGE PIN Change remote access code (0000).
The Time Saver function answers calls after six ring signals, until the rst new message has been registered
- then the answer machine switches to answering after approximately two signals. This is useful when using
remote access; if you call up the answer machine and there is no reply after four rings that means there are no
messages recorded and you can hang up before you are charged for the call.
Remote activation
The answer machine can be activated via the remote access functions.
1. Call the answer machine. It will answer after approximately 10 rings.
2. Press
*
when the outgoing message is played.
3. Enter the PIN code, see Answer machine Settings.Onebeepconrmscorrectcode.
4. Press
7
.
5. Replace the handset.