Filter
Top Products
4
3. Requirements
In order to install the DPH-10U VoIP USB Phone you will need the following:
1. DPH-10U VoIP USB Phone
2. PC with the following minimum specifications:
o Pentium 400MHz or equivalent
o Windows 2000 or XP
o Available USB port (1.0, 1.1 or 2.0)
o Skype™ version 1.1.079 or higher (www.skype.com) must be installed
o 128MB RAM
o 10MB available hard disk space
o CD-ROM drive to install DPH-10U software from the supplied
CD-ROM
4. DPH-10U Installation
The following instructions will guide you to through the process of installing
the DPH-10U VoIP USB Phone.
The installation procedure is to:
• Install Skype™ (step 1 below)
• Plug in the DPH-10U WHEN INSTRUCTED TO DO SO (step 2 below)
• Start the DPH-10U software installation (step 3 below)
• Following the installation is OK (step 3 below)
• Use your DPH-10U to make Skype™ calls
The detailed instructions follow:
STEP 1: If Skype™ is not already installed on your computer, visit
http://www.skype.com and follow the instructions there to install Skype™. Verify
that Skype™ is working before installing the DPH-10U.
STEP 2: Connect the DPH-10U USB port as shown below.
You will see the following popup. Press Yes to proceed or No to cancel.
Connect to PC Connect to NB