Filter
Top Products
3.5 FOUR-DIGIT ENTRY CODES
Four-digit entry codes are entered on the system keypad preceded by # to allow the resident access.
Do not confuse four-digit entry codes with a five-digit device code entered from a weigand keypad.
3.5.1 Programming Four-digit Entry Codes
1. Press * 0 2 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in
3.4.1) then press * (beep).
3. Enter the four-digit entry code _ _ _ _ then press * (beep).
4. Repeat steps 2 and 3 to enter additional entry codes.
5. Press 0# TOGETHER to end this programming step (beeeeeep).
3.5.2 Delete Four-digit Entry Codes
1. Press * 0 2 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in
3.4.1) then press * (beep).
3. Press # # # # * (beep).
4. Repeat steps 2 and 3 to delete more entry codes.
5. Press 0# TOGETHER to end this programming step (beeeeeep).
3.5.3 View Four-digit Entry Codes
1. Press * 1 0 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in
3.4.1) then press * (beep).
3. The entry code programmed under the directory code entered in step 2 will be
displayed.
4. Repeat step 2 to view additional entry codes.
5. Press 0# TOGETHER to end this programming step (beeeeeep).
3.5.4 Entry Code Divide Number
Entering a four digit divide number in this step will set which entry codes operate which relay. Entry
codes up to and including the divide number programmed will activate relay 1. Entry codes higher
than the divide number will activate relay 2.
1. Press * 1 2 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the four-digit divide number _ _ _ _ then press * (beep).
3. Press 0# TOGETHER to end this programming step (beeeeeep).
37