Filter
Top Products
5.
Table to select tones:
Coding the receiver:
1. Open the receiver case by inserting a small
screwdriver into one of the pry notches on
the
side of the case. (refer to receiver manual)
2. Gently lift off the front cover.
3. Locate the eight dip switches on the receiver
and
make sure they are set identically to dip switches
1-8 on the transmitter.
Note: If more than one transmitter is
used with the receiver, the first eight dip
switches of all transmitters must match
the eight dip switches of the receiver.
Note: Whenever a change is made to any
jumper or the dip switches, the receiver
must be turned OFF and then back ON
to operate properly.
Frequency: 433.92 MHz
Operating range: -30˚F to 120˚F
Battery life: 6-12 months
LOW BATTERY ALERT: If the receiver
sounds a second alert 30 seconds after
the rst alert, provided nothing trips the
transmitter again, the 9-volt battery in
the transmitter should be changed.
Switch 9 Switch 10
Channel
Tune
On On 1
Classical
O On 2
Westminster
On O 3
Ding Dong
O O 4 Whistle