Filter
Top Products
Operation: (Always test unit prior to installation)
The control box is powered by one 9-volt battery.
Coding the transmitter:
Note: The transmitters and receivers are preset
at the factory. DO NOT change settings, unless
changing the tune or experiencing false signals.
1.
Open the transmitter box. The first thing you
will see is
the air switch (Figure 2). Directly below the air switch
is the transmitter’s radio (Figure 3).
2. Locate the dip switches on the radio (2)(3).
3. Switches 1-8 are for the frequency setting
(256
combinations). If needed, set
switches 1-8 (2) to
match the eight switches in the receiver.
4. Switches 9 and 10 (3) are for the channel setting on
the transmitter. Use these to set the tone you prefer.
The four channels are listed in the table on page 5
.
3.
figure 1
3+
feet