Filter
Top Products
11
(Unlock symbol) on the transmitter to unlock driver’s door only, then press the #2 button again within 2-4
seconds to unlock remaining doors. This feature is optional and requires additional parts and/or labor.
HOOD OPEN SAFETY (Requires grounding hood pin installation)
Prevents the engine from being Remote Started when hood is open and will shut OFF the engine if opened
during while remote started. Eliminates risk of injury to someone working under the hood of the vehicle with a
properly working hood pin installed. If Remote Start button is pressed with the hood open, the lights will flash
once and the unit will not attempt a start.
BRAKE PEDAL RESET
Prevents starting or shuts off a remote started vehicle when this circuit is active or activated. Prevents unauthorized tampering.
This circuit shuts the system down immediately when brake pedal is pressed if the key is not in ignition and turned to the ON
position.
OEM ALARM INTERFACE
This feature is designed to Disarm and Re-arm Factory equipped security systems in conjunction with remote start and keyless
entry (if needed for your vehicle). This feature will maintain the original integrity and security of your vehicle’s factory equipped
systems before, during, or after remote start.
NOTE:
When changing, charging, or jumpstarting the vehicle’s battery we recommend removing the main power
fuses located on the heavy gauge RED wires near the remote start module.
TRANSMITTER PROGRAMMING
Note: All transmitter codes must be learned at time of programming!! The unit will learns up to 4
different transmitter codes.
1. Open Hood (If no hood pin installed with your system, then you must ground the Blue Hood pin wire).
2. Turn key to the ON position.
3. Press Programming button 4 times, then after a few seconds the unit flashes the parking lights 4 times.
4. Press button #1 on the transmitter to be coded. You should get 2 light flashes indicating the unit is waiting
for a 2
nd
code, then press button #1 on the second transmitter, the unit will flash 3 times indicating its
waiting for the 3
rd
code and so on. If all 4 codes are learned, the unit will automatically exit code learning
mode, otherwise turn key off and close hood. See diagram below.